PoE+ Injector

 

 

 

Increased Flexibility, Reduced Installation Time and Cost 

The Starview PoE injector allows delivery of both data and power
to a Starview access point over a single Ethernet cable, allowing
deployment of devices exactly where they are needed to provide
the best wireless coverage at a much lower installation cost.

 

Application

• 1 Port at 10/100/1000 Mbps
• Supports Up to 35W of POE power
• Compatible with IEEE 802.3af/at Standards
• Easy Installation - Parallel Slide-in Design for Multiple Units
• Safety Protection on Low Power Devices

 

Features 

Use PoE Injector with PD to expand your network to where there are no power lines or outlets,
where you wish to fx devices such as APs, IP Cameras or P Phones, etc.

 

EE0 

 

Steps:
1.Use a CATS UTP cable to connect port of Ethernet device to the DATA N port
2.Connect AC cable with Injector and Socket
3.Connect the PoE OUT port to a PD with CATS lJTP cable.

 

 

Specification

No. of channels:10/100/1000 Mbps
Pass Through Data Rates
• Pin Assignment and Polarity: 1/2 (-), 3/6 (+)
• Output Power Voltage: 5OVDC
• User Port Power: 15.4W /35W
Input Power Requirements
• AC Input Voltage: 100 to 240 VAC
• AC Input Current: 0. 5A 100-240 VAC
• AC Frequency: 50 to 60 Hz
Dimensions:145 mm x 60mm x 40mm
Indicators
• System Indicator: AC Power
• User Indicator: Channel Power
Connectors:
Shielded RJ-45, EIA 568A and 568B
Protection
• Over current protection
• Over load protection
• Over voltage protection
• Over voltage protection
Environmental Conditions
• Operating Ambient Temperature:-10℃ to 45℃
• Operating Humidity:Maximum 85%, Non-condensing
• Storage Temperature: :-10℃to 60℃
• Storage Humidity: Maximum 90%, Non-condensing